![\"The](\"http:\/\/blog.lablanchepoterie.com\/wp-content\/uploads\/2010\/12\/mixing-clay.jpg\" "\\"mixing")
<\/a><\/p>\nThe bucket of scrap clay just before mixing. Into the bucket goes all scraps, the slurry water from the splash pan around the wheel head and the water from my little bucket I use when at the potter’s wheel. Nothing goes down the drain. \u00a0Note the clumps of clay just under the water line.<\/em><\/p>\n Step 2.<\/p>\n Use a paint stirrer on the end of a drill to mix the clay. \u00a0Go slowly to start so you avoid splashing liquid clay everywhere.<\/p>\n It’s a little messy, but I can’t imagine throwing out clay that can this easily be recycled. \u00a0I recycle about 200 lbs of clay each year!<\/em><\/p>\n Mix until smooth, like cake batter. \u00a0Mmmmmm…cake batter…<\/p>\n Step 3.<\/p>\n Now it is ready to pour onto your plaster slab for drying.<\/p>\n This is the plaster slab I use for drying the clay. The clay is not completely dried, however. The plaster draws the moisture out of clay. I remove the clay from the plaster when it’s a good consistency for wedging (kneading), cut it into smaller pieces and bag it and date it. \u00a0I use the clay when it has “aged” a year or more.<\/em><\/p>\n Making a plaster slab isn’t too tricky or labour intensive and I will blog about it one day when I make a new one, as mine is wearing down and slowly disintegrating after being in use for about 7 years now. \u00a0The trick is to buy FRESH plaster and use the plaster right away. \u00a0Plaster takes on moisture from the air and if you have old stuff it probably isn’t workable. \u00a0I had a bag of plaster that I bought and then stored for two years. \u00a0When I decided to use it, it was as hard as a rock and I had to throw it out.<\/p>\n I use a jug or a ladel to scoop the clay out of the bucket and onto the plaster slab because I can’t lift the whole bucket to pour it out. \u00a0No need to hurt myself, is there?<\/em><\/p>\n I smooth out the clay and make it a consistent thickness on the plaster slab. \u00a0It takes about a week or so to firm up so I can remove it from the plaster. \u00a0Each batch of recycled clay weighs about 40-50 pounds after the water has leeched out. \u00a0Ka-ching!! That means I save about $30 or more each time I recycle a bucket of clay.<\/em><\/p>\n","protected":false},"excerpt":{"rendered":" Step 1. Toss all your scrap clay and clay water\/slurry into a large bucket. Collect until the bucket is 75% full. The bucket of scrap clay just before mixing. Into the bucket goes all scraps, the slurry water from the … Continue reading <\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n